By Teece, published Jul 21, 2014


Here is a little desk lamp I created. It was printed on a Prusa i3 using a .5mm print head. All parts fit together tightly and do not require glue. The lamp kit was purchased from a home improvement store, it's called Portfolio Candelabra Base Switch Cord (Model# 864L) and was about $5. I used a LED bulb since they produce little to no heat. There are two versions of the lamp shade, both are very strong but one will take a little less time to print. Total print time for me was around 12 hours, most of that was the shade. Enjoy!

More from 3d printing

+ See All


No instructions provided.


You must be logged in to post a comment.

By using this site you accept the use of third party cookies for analysis, personalized content and advertising.       Close       More information