KeyHide

By aurelius, published Jul 21, 2014

Description

* Usable with different Key types * Mountable with 2 Screws, glue or double-sided tape (screws preferred) * Under desk or wall assembly, your choice Best results with PLA / ABS, 2 Perimeter, 3 full Top/Bottom Layers, 50% honeycomb infill with a 0.4 mm nozzle. If your printer melts the feather holder gap with the bottom, you must cut them free.

More from Containers

+ See All

Instructions

The pictures shows a print in green ABS (1.75 mm) * Sliced with Slic3r 1.0.0r2 * 2 Perimeter * 3 full Top/Bottom Layers * 30% honeycomb infill * 0.2 mm Layer height * Perimeter Speed 50 mm/s Printed on my custom style Delta with a 0.4 mm Hexagon Hotend.

0 Comments


You must be logged in to post a comment.


By using this site you accept the use of third party cookies for analysis, personalized content and advertising.       Close       More information