Kazoo

By wes, published Jul 21, 2014

Description

3D printable kazoo instrument, just add wax paper! Just print, assemble the parts, add wax paper, and you're ready to hum.

More from Music

+ See All

Instructions

For full kazoo in 1 print use the Kazoo_All.STL file & make sure to use exterior support, for the valve to print properly. Each part is also available in a separate file, only the valve needs support, the cap and body are fine to print without. To play; • Insert the valve into the main body • Cut a small piece of wax paper (about 1" square) & place it on top of the valve • Gently push the cap over the wax paper and onto the valve • For best sound, hum into the larger end • Enjoy! Object height: 119mm STP and STL formats available.

0 Comments


You must be logged in to post a comment.


By using this site you accept the use of third party cookies for analysis, personalized content and advertising.       Close       More information